Ruijie Community

Title: Issue facing after meshing my APs [Print this page]

Author: Muhammad Ahmed Time: 2023-9-23 19:07
Title: Issue facing after meshing my APs
I have connected three APs 2260G ,2200E,2200E,my master is 2260G ,the issue is that when my one of the slave disconnects,it doesn't connect with the master automatically and taking too much time,so what can be the problem?

Author: guominxiang@rui Time: 2023-9-23 21:00
May I know did you enable enable Self-Healing Mesh function on salve AP?

You can refer to this post: https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=6678

Author: Muhammad Ahmed Time: 2023-9-25 15:22

GTAC-Micca replied at 2023-9-23 21:00
May I know did you enable enable Self-Healing Mesh function on salve AP?

You can refer to this post ...

yes it' on.

Author: Muhammad Ahmed Time: 2023-9-26 15:08

Muhammad Ahmed replied at 2023-9-25 15:22
yes it' on.

Facing the problem still

Author: guominxiang@rui Time: 2023-9-27 14:30

Muhammad Ahmed replied at 2023-9-26 15:08
Muhammad Ahmed replied at 2023-9-25 15:22
yes it' on.Facing the problem still

1. May I know the device distance pls?
2. If your device is managed by Ruijie Cloud, may you share the project with read&write permission to my email address pls? guominxiang@ruijie.com.cn
3. if it doesn't connect with the master automatically, may I know what did you do to make it mesh again? May you describe this progress for me pls?

Author: Muhammad Ahmed Time: 2023-9-30 19:25

GTAC-Micca replied at 2023-9-27 14:30
1. May I know the device distance pls?
2. If your device is managed by Ruijie Cloud, may you share ...

The issue is resolved, the range of AP mesh in less than 10metres so it worked,the key was to update the firmware for meshing as it was'nt showing the option first but upgrade resolved it.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)