Ruijie Community
Title: Device cannot go online on Ruijie Cloud [Print this page]
Author: Oscar Time: 2018-8-13 19:52
Title: Device cannot go online on Ruijie Cloud
1. Check Network Connectivity
1) Verify the connectivity between Ruijie device and Ruijie Cloud.
ping devicereg.ruijienetworks.com on device CLI.
2) Whether your device's IP address, gateway, DNS server are configured
Ruijie(config)#int bvi 1
Ruijie(config-if)#ip address 192.168.1.1 255.255.255.0 //configure IP
Ruijie(config-if)#end
Ruijie(config)#ip route 0.0.0.0 0.0.0.0 192.168.1.254
//configure gateway
Ruijie(config)#ip name-server 8.8.8.8 //configure DNS
3) Following ports are used for Ruijie Cloud management. Ensure these ports are available and the data stream is permitted.
Note: AP and SMB switch have default CWMP setting which allows devices can look for Ruijie Cloud automatically. But for enterprise switch(RG-S29 series), It needs to configure CWMP URL on CLI manually.
Ruijie#configure ter
Ruijie(config)#cwmp
Ruijie(config-cwmp)#end
Ruijie#wr
2. Check Device Running Mode(Wireless only)
Verify whether the AP is running in FAT mode, if the device is working in FAT mode, it needs to switch AP into macc mode on WEB or CLI for Ruijie Cloud registration. the command are following
Ruijie#ap-mode macc
Note: By default, AP is running in FIT Mode and will convert MACC mode automatically once it has Internet access.
3. Check Ruijie Cloud Hosting(Asia or Europe)
1) In order to provide smooth access and reduce Internet latency for users in Ruijie Cloud solution. There is 2 Ruijie Cloud hosting installed for global service. The dynamic hosting selection for regions or countries shows as below:
2) As 2 hosting databases are isolated, if the serial number you input on and the device DNS resolution is not the same hosting, the device will not show online. First, verify which hosting you are accessing in the browser. Simply login your Ruijie Cloud account, and check the URL link.Cloud-as represents Asia cloud and cloud-eu is Europe Cloud. Then, login device's cli and execute ping cloud.ruijienetworks.com and check which IP address is resolved.(Asia-35.197.150.240,Europe-35.234.108.108). Please confirm the cloud hosting you are accessing is the same as the one device registered.
4. Check Device Firmware
Whether the device is running the latest firmware as Ruijie Cloud recommended, if the firmware version is too old, it may not be compatible with Ruijie Cloud. User can log in device's web or cli and upgrade to latest firmware version. Please refer Ruijie Cloud Supported Model and Recommended Firmware Version:
5. Check Serial Number
Whether the device's serial number is matched with the one displayed on Ruijie Cloud. The serial number can be found on device back panel or exec "show version" on CLI.
6. Check CWMP configuration
The following is right cwmp configuration:
show cwmp configuration
CWMP status : enable
ACS URL :
If the configuration is wrong, you can use the command following to
change.
AP#config ter
AP(config)#cwmp
----you can replace 'devicereg' to 'cwmpsvr-as' or 'cwmpsvr-eu' base on the cloud you are using.
AP(config-cwmp)#end
AP#wr
Author: joey.lozano@dep Time: 2022-9-28 17:47
Not helpful at all. The steps are not easy to follow with normal people.
Author: GTAC-Sophia Time: 2022-9-29 13:56
Hello Sir,
I apologize for not being able to solve your problem. Could you describe your problem briefly, so that we could provide correct solutions to you.
Author: info@onem.com.t Time: 2022-10-1 21:34
cwmp configuration was disabled. It went online 1 minute after activating it. Thank you.
Author: chanary.hul@pos Time: 2023-2-23 18:20
Hello Sir,
I have the same problem with that, sir. I have two RG-S5750C-48SFP4XS-H devices that are set up as VSU, however when I follow that guide, just one switch goes online. Please give me some advice on this.
Thanks.
Author: GTAC-Micca Time: 2023-2-24 11:11
Sorry for the inconvenience that not supporting the VSU scenario
Author: chanary.hul@pos Time: 2023-2-24 16:46
Hello Sir,
So it mean when the switches that configure VSU it can't online both devices right ?
Thanks
Author: guominxiang@rui Time: 2023-2-27 22:17
yes, correct
Author: administrador@k Time: 2023-2-28 01:55
I´m having the same problem with 9 AP820-L(V2) and 1 AP720-L. They were working fine and suddenly they went Offline in Ruijie Cloud. Antenas are reachable by IP and they are working fine. How can I see them Online in Ruijie Cloud again?
Regards
Author: liuxiyang@ruiji Time: 2023-3-1 14:31
Hi sir,
May I know do you mean that the AP network is normal but offline now? Could you check according to the troubleshooting steps in this link? Could you please share network with me? This is my email:liuxiyang@ruijie.com.cn
Author: kychame@gmail.c Time: 2023-3-5 09:00
Hi sir.. i do have problem like that.. network normal, the only problem is cloud server not online.. can you help.. thanks
Author: liuxiyang@ruiji Time: 2023-3-6 09:09
Hi sir,
Sorry for my late reply.
Could you please share network with me? This is my email:liuxiyang@ruijie.com.cn
Author: Surapat.taesura Time: 2024-5-14 01:33
Hi Sir,
My problem occurred after replacing ISP'router which resulted in APs that were online in the Cloud showing offline status.
but Actually brand are AP(ruijie) > PoE Switch (TP-Link) > Gateway Switch (CBS-Cisco) > ISP'Router
Author: v-anakaren@ruij Time: 2024-5-14 08:46
Dear,
Could you share the model of the AP?
Please check if the UDP and TCP ports are enabled on the ISP or gateway switch.
Author: Surapat.taesura Time: 2024-5-14 12:49
Hi,
My AP's Model is RAP2260(G)
Could you please share me a UDP & UTP port in conclusion for allow ap to join cloud dashboard.
Author: guominxiang@rui Time: 2024-5-14 12:55
Hello,
Do you want to ask which ports need to be released?
I have shared the port that cloud-as.ruijienetworks.com needs to be released according to your location, please check the following table. If you have other questions please keep talking to me and I will be happy to help you on the community
| Welcome to Ruijie Community (https://community.ruijienetworks.com/) |
Powered by Discuz! X3.2 |
