Ruijie Community

Title: How to configure smart flow control on Reyee EG? [Print this page]

Author: zhangqiao@ruiji Time: 2024-4-7 14:27
Title: How to configure smart flow control on Reyee EG?
1. Overview
When you need to limit the uplink traffic and downlink traffic bandwidth of the device ports (such as WAN and WAN 1), you can enable the smart flow control function. After the line bandwidth is configured for a port, the uplink and downlink traffic of the port will be limited within the specified range. In addition, the per user bandwidth should be intelligently adjusted according to the number of users to ensure that users fairly share the bandwidth.
2. Configuration Steps
ChooseOne-Device > Gateway >Config > Behavior> Flow Control > SmartFlow Control.

Turn on Enable on the Smart Flow Control tab andset the line bandwidth based on the bandwidth actually allocated by the ISP. If the device has multiple lines, you can set the bandwidth for these WAN ports separately.
Click Save to make the configuration take effect.
Caution: Enabling flow control willaffect network speed testing. If you want to test the network speed, disable flow control first.
Table 1-1 Smart flow control configuration

Parameter	Description
Enable	Specify whether to enable the smart flow control function. By default, smart flow control is disabled.
WAN Bandwidth	Set the uplink and downlink bandwidth limits for the WAN ports, in Mbit/s.

Note:
Smart flow control can beused to control the line traffic in different networking modes, including bandwidth-based, static IP address, and dynamic IP address.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)