Ruijie Community

Title: How to configure NAT-DMZ on Reyee EG? [Print this page]
Author: zhangqiao@ruiji    Time: 2024-4-7 15:59
Title: How to configure NAT-DMZ on Reyee EG?
Choose One-Device > Gateway >Config > Advanced> Port Mapping >NAT-DMZ.
Click Add.Enter the rule name and internal server IP address, select the interface towhich the rule applies, specify the rule status, and click OK. You can configure only one DMZ rule for an outbound interface.


Table 1-1 DMZ rule configuration
   Parameter
   		   Description
   
  Name
  		  Enter  the description of the mapping rule, which is identify the DMZ rule.
  
  Dest  IP Address
  		  Specify  the IP address of the DMZ host to which packets are redirected, that is, the  IP address of the internal server that can be accessed from the Internet.
  
  Outbound  Interface
  		  Specify  the WAN port in the DMZ rule. You can configure only one rule for a WAN port.
  
  Status
  		  Specify  whether the rule is effective. The rule is effective after you turn on Status.
  




Welcome to Ruijie Community (https://community.ruijienetworks.com/) Powered by Discuz! X3.2