Ruijie Community

Title: Mesh with Rap-6260H [Print this page]

Author: matteotese@gmai Time: 2024-5-7 07:21
Title: Mesh with Rap-6260H
Hello, I have a Rap-6260H connected by lan. I just buy a Rap 6262h because I want to mesh it with the 6260H. The 6260h doesn't have a mesh button. How can I connect them? (my 6262h is not the primary router)

Author: chenzixuan3@rui Time: 2024-5-7 12:06
Dear sir
there are no mesh button on the Reyee AP , the mesh function is enable by default , you can refer the following link to mesh
RAP Mesh Networking Introduction - Wireless - Ruijie Community (ruijienetworks.com)

Author: matteotese@gmai Time: 2024-5-11 05:15

GTAC-Joy replied at 2024-5-7 12:06
Dear sir

there are not mesh button on the Reyee AP , the mesh function is enable by default , you ...

Today I tried but the 6262 doesn't connect with the 6260H. They are 15mt away from each other. The 6262 is installed on a guest house with a different electrical system.
Can a different electrical sistema respect the main house cause this problem?

Author: chenzixuan3@rui Time: 2024-5-11 09:44

Matteo Vitale replied at 2024-5-11 05:15
Today I tried but the 6262 doesn't connect with the 6260H. They are 15mt away from each other. The ...

Dear sir

Different device models can also be mesh. Please pay attention to a few points during the configuration process.
1. The slave AP must be factory-set.
2. The slave AP cannot be wired into the same network as the master device
3. Both APs must be the latest version

Welcome to Ruijie Community (https://community.ruijienetworks.com/)