Title: How to configure PPTP? [Print this page] Author: zhangqiao@ruiji Time: 2024-5-10 17:29 Title: How to configure PPTP? 1. Configuring the PPTP Service 1.1 Configuring the PPTP Server
Choose One-Device > Gateway > Config > VPN > PPTP > PPTP Settings
Turn on the PPTP function, set PPTP Type to Server, configure PPTP server parameters, and click Save. Caution
The local tunnel address and IP address range of the address pool cannot overlap the network segment of the LAN port on the device. 2 Configuring PPTP User
Choose One-Device > Gateway > Config > VPN > VPN Account.
Only user accounts added to the VPN client list are allowed to dial up to connect to the PPTP server. Therefore, you need to manually configure user accounts for clients to access the PPTP server
Click Add. In the dialog box that appears, set Service Type to PPTP or ALL. (If you select ALL, the created account can be used to establish all types of VPN tunnels.) Enter the username, password, and peer subnet, select a network mode, and click OK. 3. Configuring the PPTP Client
Choose One-Device > Gateway > Config > VPN > PPTP > PPTP Settings
Turn on the PPTP function, set PPTP Type to Client, configure PPTP client parameters, and click Save. 4. Viewing the PPTP Tunnel Information
Choose One-Device > Gateway > Config > VPN > PPTP > Tunnel List.
It takes some time to establish a VPN connection between the server and client. After the configuration of the server and client is completed, wait for 1 to 2 minutes to refresh the page and view the PPTP tunnel establishment status
Welcome to Ruijie Community (https://community.ruijienetworks.com/)