Ruijie Community

Title: How to enable dual wan (multi-wan) for EG105G-P-V2? [Print this page]

Author: tireengatau@gma Time: 2024-6-9 10:51
Title: How to enable dual wan (multi-wan) for EG105G-P-V2?
Can anyone help to guide a step by step to enable dual wan for EG105G-P-V2?

Any help will be greatly appreciated thanks.

Author: liujunhui1@ruij Time: 2024-6-9 13:02
Dear sir

You can enable this function on the device

best regards,
Ross

Author: carlos.segala@g Time: 2024-12-1 02:38

GTAC-Ross replied at 2024-6-9 13:02
Dear sir

You can enable this function on the device

Hi, I have load balancing configured for 2 WANs, but I don't see where the failover is. For example, if an interface goes down, how can I check that it went down to only take you out through the one that is active?RegardsPS: I don't see the Line Detection Option

Author: v-xiewenyu@ruij Time: 2024-12-1 09:55

User 49978 replied at 2024-12-1 02:38
Hi, I have load balancing configured for 2 WANs, but I don't see where the failover is. For exampl ...

Dear sir,
Good day.
May I know your device model?
Please help to check the firmware version of your device is the latest one or not. If not, please upgrade the firmware first.

Best regards,
Lex

Author: v-xiewenyu@ruij Time: 2024-12-1 09:55

User 49978 replied at 2024-12-1 02:38
Hi, I have load balancing configured for 2 WANs, but I don't see where the failover is. For exampl ...

Dear sir,
Good day.
May I know your device model?
Please help to check the firmware version of your device is the latest one or not. If not, please upgrade the firmware first.

Best regards,
Lex

Welcome to Ruijie Community (https://community.ruijienetworks.com/)