Ruijie Community

Title: Mesh AP not linking to strongest signal [Print this page]

Author: alex@hypex.co.z Time: 2024-7-12 21:24
Title: Mesh AP not linking to strongest signal
Hello there,
I have EG105GW-X as gateway and few wired RAP2260(G) and one wireless RAP2260(G) that has been meshed, however, it always connects to EG105GW-X instead to close by wired RAP2260(G). Is there any way for me to manually set it up through cloud or to scan and choose which AP I would like to connect to? I don't want to run AI tools.

Author: liujunhui1@ruij Time: 2024-7-12 21:29
Dear sir

in that case, you can configure wireless repeater mode on the AP
and you can manunlly choose the SSID you want to expand the wifi coverage

Best regards,
ROss

Author: alex@hypex.co.z Time: 2024-7-12 21:31
Edited by Alexander P at 2024-7-12 21:35

GTAC-Ross replied at 2024-7-12 21:29
Dear sir

in that case, you can configure wireless repeater mode on the AP

I was thinking about it but I'm not on site any longer, can I tunnel into mesh AP and do it without being disconnected to finalise the setup?
It looks like I have to set it up from the scratch.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)