In the configuration template, the default-router command is not configured for the DHCP pool. Does this affect the client to obtain the IP address of the gateway? - Ruijie Community

In network planning, if the default-router command is not configured, the device sends the interface address, as the gateway address, to the client by default. For example, if the network segment configured for the DHCP is 10.0.0.0/24 and the IP address of the VLAN100 interface is 10.0.0.1/24, if the default-router command is not configured, the device sends the IP address of the SVI100, as the gateway address, to the client. It is recommended to configure ”default router” during network deployment because it makes the configuration command planning clear and easy to check.