Ruijie Community

Title: What is the priority of speed limit in RAP and how to configure it? [Print this page]

Author: zhangqiao@ruiji Time: 2024-9-10 18:02
Title: What is the priority of speed limit in RAP and how to configure it?
1. Configuration tips
1.1 Button of Wireless Rate Limiting must be enabled before you configured

1.2 The meaning of different speed limit rules

TYPE	Description
Terminal speed limit	Client-based Rate Limiting		The specified terminal speed limit can be configured. Highest priority
	SSID-based Rate Limiting	Per User	Configure the same speed limit for all terminals in the SSID
		All users	Configure the sharing speed of all terminals in this SSID
	AP-based Rate Limiting		Configure the same rate speed for all AP downlink terminals on the network
Packet limit	Packet-based Rate Limiting		To provide users with downlink based broadcast, multicast packet speed limit

2. Support Models
This function is supported by only the RG-RAP2260(G), RG-RAP2260(E), RG-RAP6260(G), RG-RAP6262(G), RG-RAP2260(H), RG-RAP6260(H), RG-RAP6260(H)-D, RG-RAP2266, RG-RAP2260, RG-RAP2266-V2, RG-RAP2260-V2, RG-RAP1261, RG-RAP1260, RG-RAP6262, RG-RAP2200(E) (hardware version V2.00 or later, as indicated on the device label), RG-RAP2200(E)-V2, RG-RAP52-OD and RG-RAP73HD.
3. Configuration Steps
3.1 Configuring Client-based Rate Limiting
Choose Network-Wide > Workspace > Wireless > Rate Limiting > Client-based Rate Limiting.
(1) Enable Wireless Rate Limiting.

(2) Click Add. In the dialog box that appears, set the MAC address and uplink and downlink rate limit values of the client, and click OK.

3.2. Configuring SSID-based Rate Limiting
Choose Network-Wide > Workspace > Wireless > Rate Limiting > SSID-based Rate Limiting.
(1) Enable Wireless Rate Limiting.
(2) Click Edit in the Action column of the target SSID. In the dialog box that appears, set the uplink and downlink rate limit modes and values, and click OK.

3.3. Configuring AP-based Rate Limiting
Choose Network-Wide > Workspace > Wireless > Rate Limiting > AP-based Rate Limiting.
(1) Enable Wireless Rate Limiting.

3.4. Configuring Packet-based Rate Limiting
Choose Network-Wide > Workspace > Wireless > Rate Limiting > Packet-based Rate Limiting.
(1) Enable Wireless Rate Limiting.
(2) Select the specific type of packets for rate limiting, configure the rate limit value, and click [strong]Save[/strong].

Priority
Client-based Rate Limiting > SSID-based Rate Limiting(Per User) > AP-based Rate Limiting > SSID-based Rate Limiting(Shared)
The uplink and downlink priorities are calculated separately.
For example:
Rule 1: Client-based Rate Limiting(uplink only)

Rule 2: SSID-based Rate Limiting-Per User(uplink& downink)

If 2 rules are configured at the same time, the uplink takes effect based on the user and the downlink takes effect based on SSID.
4. Verification
Test comparison before and after configuring speec limiting

Welcome to Ruijie Community (https://community.ruijienetworks.com/)