Ruijie Community

Title: Uplink Speed [Print this page]

Author: penalosajericho Time: 2024-10-18 21:15
Title: Uplink Speed
Hi just want to verify the Uplink and Downlink speed is this the throughput?
I'm using the EG Series Load Balancer.

Author: v-xiewenyu@ruij Time: 2024-10-18 23:14
Dear sir,
Good day.

Yes, this is the real time speed record chart of the EG.
You can use this chart to see the peak values of uplink and downlink speeds at a certain moment.

Best regards,
Lex

Author: penalosajericho Time: 2024-10-18 23:53

GTAC-Lex replied at 2024-10-18 23:14
Dear sir,
Good day.

So this is the whole output of the device sir. Correct?
Thanks sir Lex

Author: penalosajericho Time: 2024-10-18 23:56
Another question sir Lex we can always monitor them but can we access the gateway remotely I mean I'd
like to reconfigure the Load Balance Settings of the gateway but I'm not in the area currently.

Author: v-xiewenyu@ruij Time: 2024-10-21 10:17

Jericho Penalosa replied at 2024-10-18 23:56
Another question sir Lex we can always monitor them but can we access the gateway remotely I mean I' ...

Dear Jericho,
Good day.
If your device is on Ruijie Cloud, you can try create this eWeb tunnel on the Cloud.
With the tunnel created, you can visit your device locally.

Best regards,
Lex

Author: penalosajericho Time: 2024-10-21 19:34

GTAC-Lex replied at 2024-10-21 10:17
Dear Jericho,
Good day.
If your device is on Ruijie Cloud, you can try create this eWeb tunnel on ...

THanks Lex. Another thing sir why does my throughput max speed only shows 1 as the highest?

Below is my load balance settings:

Author: wangyanjun3@rui Time: 2024-10-21 21:04

Jericho Penalosa replied at 2024-10-21 19:34
THanks Lex. Another thing sir why does my throughput max speed only shows 1 as the highest?

Dear customer
Do you mean the speed limit is not in effect?

Best Regards
Tom

Author: penalosajericho Time: 2024-10-21 22:16

GTAC-Tom replied at 2024-10-21 21:04
Dear customer
Do you mean the speed limit is not in effect?

Yes kinda because for other devices it shows 300mbps to 500mbps

Author: v-shaojinren@ru Time: 2024-10-22 09:28

Jericho Penalosa replied at 2024-10-21 22:16
Yes kinda because for other devices it shows 300mbps to 500mbps

Dear Penalosa,
It could be that there was not much traffic moved through the WAN ports when you monitored it. You can run a speed test(https://www.speedtest.net/
) on a device connected to the EG and check if the traffic spikes.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)