Title: RAP52 OD disconnecting after pairing [Print this page] Author: hilton.britten@ Time: 2024-10-20 18:15 Title: RAP52 OD disconnecting after pairing Good day, i have 4 x RAP52 OD units. I have created a project and successfully added my main unit, after scanning for new devices the other 3 come up. After clicking on the pairing i get red explanation marks on all 3 then it shows them as disconnected. i would greatly appreciate help as my client is about to go crazy Author: v-xiewenyu@ruij Time: 2024-10-21 09:49
Dear Hilton,
Good day.
If the device has been successfully meshed before, you can try the Self-Healing Mesh function and the system will automatically repair the Mesh network.
If the Mesh has not been successful, please follow the instructions below:
1. Make sure the factory settings of the slave APs have been restored before the Mesh;
2. Make sure that the distance between APs does not exceed 5 metes during the Mesh (you can put them back to the required position after the Mesh is completed);
3. Ensure that each Mesh AP is powered normally. For 52OD, please make sure that its power supply method is IEEE 802.3af 24 V passive PoE. (If the power supply is insufficient, the 5G antenna radio required by the Mesh will not work, resulting in Mesh failure).
Best regards,
Lex
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
