Title: What is static route function on Reyee gateway? [Print this page] Author: zhangqiao@ruiji Time: 2024-11-14 11:33 Title: What is static route function on Reyee gateway? Static routes are manually configured by the user. When a data packet matches a static route, the packet will be forwarded according to the specified forwarding mode.
Caution: Static routes cannot automatically adapt to changes of the network topology. When the network topology changes, you needto reconfigure the static routes. Configuring IPv4 Static Routing
Choose One-Device > Gateway > Config >Advanced > Routing > Static Routing
Click Add. In the dialog box that appears, enterthe destination address, subnet mask, outbound interface, and next-hop IPaddress to create a static route.
After a static route is created, you can find the relevant route configuration and reachability status in the static route list. The Reachable parameter specifies whether the next hop is reachable, based on which you can determine whether the route takes effect. If the value is No, check whether the outbound interface in the current route can ping the next-hop address.
Configuring the IPv6 Static Route
Choose One-Device > Gateway > Config >Advanced > Routing > IPv6 Static Routing
(1) Click Add
(2) Configure an IPv6 static route of the device.
(3) Click OK. Author: rabin.ghimire@g Time: 2025-3-26 14:56
I need specify the static route to reach internet let's in EG210G-P (ReyeeOS 2.340.0.1508).
In other router i used to use:
Dest. Ip: 0.0.0.0/0
Gateway: 172.16.1.1
outbound interface : ether1_wan
it works perfectly:
but in EG210G-P (The wan ip is: 10.10.10.1/24)
I want to reach internet through 172.16.1.1 (mid router : I have already set the static route here to reach)
