Title: How to capture packets on AC using Wireshark? [Print this page] Author: zhangqiao@ruiji Time: 2024-11-28 11:27 Title: How to capture packets on AC using Wireshark? When there are wireless 802.1x or web issues, you need capture packet to check. You can refer to the following guide to capture the auth packet on the AC.
1. Topology
2. Port Mirror Configuring the following command on AC.
Ruijie(config)#monitorsession 1 source interface gigabitEthernet 0/3both----you can change the port by enter Ruijie(config)#monitorsession 1destination interface gigabitEthernet 0/1switch
3. After the PC connects to the AC, open the wireshark, choose the interfaces to capture from, then start.
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
