Title: Can't setup snmp public on ruijie access point [Print this page] Author: mirza.ramadhana Time: 2024-12-18 15:44 Title: Can't setup snmp public on ruijie access point Dear team
I cant setup SNMP server with community public on ruijie access point series Ruijie AP820-L(V2), firmware AP_RGOS 11.9(6)W3B1, Release(11160201). The capture below
WIFI-5.4_INT-SUPPORT(config)#snmp-server community public ro
%Error: The community(public) is a weak community, not allowed to configure!
Fyi the settings on the Ruijie switch are ok please see below
snmp-server enable traps
snmp-server community public ro
!
line console 0
line vty 0 4
login local
!
end
SW2-LT2-ZONE2#sh ver
System description : Ruijie 10G Ethernet Switch with PoE (S2910C-48GT2XS-HP-E) By Ruijie Networks
System start time : 2024-12-14 10:49:34
System uptime : 4:03:53:47
System hardware version : 1.74
System software version : S29_RGOS 11.4(1)B70P1
System patch number : NA
System serial number : G1PA0KF00341A
System boot version : 1.2.28
Module information:
Slot 0 : S2910C-48GT2XS-HP-E
Cpu 0:
Hardware version : 1.74
Boot version : 1.2
Software version : S29_RGOS 11.4(1)B70P1
Serial number : G1PA0KF00341A
SW2-LT2-ZONE2#
anyone can help me ?
Thank you Author: lengjiajun@ruij Time: 2024-12-24 11:19
The public password you used is a weak password, we are not allowed to configure this password, you can change the password, and then the configuration will be successful
Welcome to Ruijie Community (https://community.ruijienetworks.com/)