Ruijie Community

Title: How to configure port aggregation in AC？ [Print this page]

Author: GTAC-Daisy Time: 2019-6-10 15:43
Title: How to configure port aggregation in AC？

configure port aggregation in AC

Ruijie>enable

Ruijie#configure terminal

Ruijie(config)#interface rangegigabitEthernet 0/1-2 ------>enter g0/1-2 at the sametime

Ruijie(config-if-range)#port-group1 ------>configure them to be AG1

Ruijie(config-if-range)#exit

Ruijie(config)#interface aggregateport 1 ------>enter AG1

Ruijie(config-if-AggregatePort 1)#switchportmode trunk

Ruijie(config-if-AggregatePort 1)#exit

Ruijie(config)#aggregateport load-balancesrc-mac ------> Changethe traffic balance mode to source MAC mode, default is source IP + destinationIP mode

Ruijie(config)#exit

Ruijie#wr

Welcome to Ruijie Community (https://community.ruijienetworks.com/)