SNMP

hi,
can we configure SNMP in FIT AP? RG-820 (V2)
if yes i whan't to push the configuration for all AP from AC ws-6512-L
Regards
ghali

Hello Ghali, the steps to configure SNMP can be founded in following configuration guide for controller




https://www.ruijienetworks.com/support/documents/slide_rg-wlan-series-access-controllers-ac-rgos11-9-6-w5-web-based-configuration-guide/?page=html&keyworks=snmp#_Toc184721555



Regards!

TAC-Saul replied at 2025-2-27 03:16
Hello Ghali, the steps to configure SNMP can be founded in following configuration guide for control ...

Hello TAC-Saul,

The setting you mentioned is only valid for the controller. The real question is how to activate snmp on APs operating in Fit mode?

ssahin replied at 2025-3-12 21:02
Hello TAC-Saul,

The setting you mentioned is only valid for the controller. The real question is  ...

Hi,you can run the ap-group command on the ac to access the ap group and configure snmp configurations for the ap group in batches

GTAC-Rachel replied at 2025-3-12 22:59
Hi,you can run the ap-group command on the ac to access the ap group and configure snmp configurat ...

Thanks for the info. I tried before but there is no snmp-server argument under ap-group. I can't run any cli command related to snmp.

hello, the solution was with ap-config. Thank you to the support team. The commands are as follows;
on AC;
configure terminal
ap-config all
exec-cmd mode configure cmd "snmp-server location TESTLOCATION"
exec-cmd mode configure cmd "snmp-server community COMMUNITYSTRING rw"
end
write
if you wish, you can also define traps after the exec-cmd mode configure cmd command.