How to make defaults restoration?

You can perform the defaults restoration operation when you want to delete all configurations of the device.

The Z-S series firewall supports web-base done-click restoration and restoration by pressing the Reset button.

Caution

The defaults restoration operation clears all the configurations. Beforeyou perform this operation, back up the configurations in time.

Web-based One-Click Restoration

Application Scenario

When you are unable to operate the hardware directly inthe equipment room, you can perform the defaults restoration operation on theweb management page.

Procedure

(1)

Choose System > System Maintenance > Defaults Restoration.

(2)

Click Restore Defaults.

Follow-up Procedure

Thedevice automatically restarts. After the restart, all configurations of thedevice are restored to factory defaults.

Restoration by Pressing the Reset Button

Application Scenario

When you can maintain the device in the equipment room,press the Reset button on the device to restore factory defaults.

Procedure

Pressand hold the Reset button on the device (for over 5s). The Reset button islocated on the front panel of the device, as shown in
Figure 1-1.

Figure 1-1    Reset Button on the Front Panel

Follow-up Procedure

The device automatically restarts. After the restart, all configurations of the device are restored to factory defaults.

Note:
The Reset button provides the following functions:

• Devicerestart: Press and hold for less than 3s.
  
• Defaultsrestoration: Press and hold for over 5s.
  
  

Both of the preceding two operations will initiate one-click collection. After the restart, you can log in to the web management page and choose
O&M > Fault Diagnosis > One-Click Collection to download the device status information.