|
For wall ap, the guide to recover firmwareis shown as below: I. Network Topology  II. Requirements 1. Generally, we recover firmware underBOOT mode if we deletes firmware on Main Mode by mistake, firmware broken orany other unknown reasons that devices cannot boot up and enter Main Mode. 2. Finish reading Device Management--> System Management & --> Firmware Upgrade, have knowledge of howto transfer firmware with TFTP server. III. Configuration Steps 1. OpenWireshark, load a packet capture process as below. AP 192.168.64.64 lostfirmware and is requesting 192.168.64.1 for firmware.  2. Assign IP address 192.168.64.1 tolaptop, enable TFTP Server and also prepare the firmware, the firmware put onsame folder with tftp server.  3. Edita notepad name as "FileList.txt", put it in the same folder as shownabove, the content is the firmware name you're going to transfer  4. AP will begin downloading firmware soon,verify by viewing TFTP Server connection status. 5. AP will reload when finish recoveringfirmware IV. Verification Login AP via telnet and AP is recovered. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
