|
a) Check the indicator of the EST device. If the wireless signal is too low to connect, you need to adjust the channel and the transmit power setting. b) Check the working mode of the device. Ensure that one side is AP mode, and the other side is CPE mode. c) Check the installation location of the EST device. Place the front panels of the two EST devices (AP end and CPE end) opposite each other to ensure that WIFI signals can be transmitted. d) Check whether the radio configuration on both sides are consistent. They are consistent by default. If they are inconsistent, you can restore factory settings of the two EST devices to test again (press the reset button for more than 5s). e) If the problem is still unsolvable, you may start a Live Chat with our Support Engineer for assistance: Ruijie Support. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 2
