AP180 logs to monitor or trace users behavior

Our AP180 was block from an internet website because of
unusual behavior detected.


Are there logs can be collected or monitoring to assist our investigation?

Hi sir,
You can check log on AP 180 cli via this command: sh log


Best regards,
Steve

GTAC-Steve replied at 2023-12-1 16:17
Hi sir,
You can check log on AP 180 cli via this command: sh log

How do I
- collect logs start from 23 Nov 2023 till today;
- download it to my computer?

IT Support Pharmacy replied at 2023-12-1 16:58
How do I
- collect logs start from 23 Nov 2023 till today;
- download it to my computer?

Hi sir,

It cannot choose time, when you enter the command, it will show all log on your AP. The log storage space is certain, and the new log overwrites the old log.

Best regards,
Steve

GTAC-Steve replied at 2023-12-1 17:07
Hi sir,

It cannot choose time, when you enter the command, it will show all log on your AP. The l ...

Thanks, Steve.
I need to get log to investigate the issue between 23 Nov 2023 to 30 Nov 2023. However, sh log displays only logs for 01 Dec 2023. Any other way to retrieve logs earlier?
Use the command sh log, it shows about 30 lines of log messages, but below in red shows 26121 messages were logged.
Syslog logging: enabled
  Console logging: level debugging, 26121 messages logged
  Monitor logging: level debugging, 0 messages logged
  Buffer logging: level debugging, 26121 messages logged
  Standard format:false
  Timestamp debug messages: datetime
  Timestamp log messages: datetime
  Sequence-number log messages: disable
  Sysname log messages: disable
  Count log messages: disable
  Trap logging: level informational, 26120 message lines logged,0 fail

IT Support Pharmacy replied at 2023-12-1 17:12
Thanks, Steve.
I need to get log to investigate the issue between 23 Nov 2023 to 30 Nov 2023. Howe ...

Hi sir,

Sorry for the inconvenience, it cannot support if you doesn't configure snmp

GTAC-Steve replied at 2023-12-1 17:19
Hi sir,

Sorry for the inconvenience, it cannot support if you doesn't configure snmp

I see. Thanks again.