EST350 V2 P2MP connectivity issue
|
Hi, See below scenario. Wireless bridge from House to building A and B. Both buildings in same direction about 250m from AP. Clear line of sight. I did P2MP by adding additional CPE. All looks fine from technical point of view but for some reason both CPEs disconnecting after 3minutes. I already tried to: -relocated antennas -replaced PoE for all units -check for interference (used all 3 modes) -used few frequencies (5180, 5300, 5700, 5800) -used different channels (20/40/80) -all reset to default config and stetted up again P2MP is not online so can not be adjusted by cloud, all changes done with remote desktop on web interface. Any Ideas ??  |
|
Dear Lukasz Ptak, Please kindly check if the devices are running the latest firmware. The latest firmware can be downloaded in the following link: https://reyee.ruijie.com/en-global/resources/software/est350v2-firmware/b11p221-firmware/ Best regards, Jayden |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
