1. Enter the eweb of Reyee EG 2. Select Gateway > Behavior > Flow control  3. Click Edit to check therelated flow control policy entry  4. Check if the user group is selected correctly  5. Compare the Application and Bandwidth types are configured according to design  6. Check if the interface should be applied on all WAN ports Note: If you select All WAN Port here, the speed test result will be the limit multiplied by the number of WAN ports. For example, the bandwidth limit is 10Mbps, and there are two WAN ports, then the speed test result will be 20Mbps approximately.  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 6
