How to enable dual wan (multi-wan) for EG105G-P-V2?
|
Can anyone help to guide a step by step to enable dual wan for EG105G-P-V2? Any help will be greatly appreciated thanks. |
|
Dear sir You can enable this function on the device  best regards, Ross |
GTAC-Ross replied at 2024-6-9 13:02 Hi, I have load balancing configured for 2 WANs, but I don't see where the failover is. For example, if an interface goes down, how can I check that it went down to only take you out through the one that is active?RegardsPS: I don't see the Line Detection Option |
User 49978 replied at 2024-12-1 02:38 Dear sir, Good day. May I know your device model? Please help to check the firmware version of your device is the latest one or not. If not, please upgrade the firmware first.  Best regards, Lex |
User 49978 replied at 2024-12-1 02:38 Dear sir, Good day. May I know your device model? Please help to check the firmware version of your device is the latest one or not. If not, please upgrade the firmware first. Best regards, Lex |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
