Fault phenomenon 1. Device VSU cannot be established Networking Topology Possible Reasons 1. Device version is inconsistent 2. The device has not switched to VSU state 3. VSU configuration error (including domain ID , device ID, etc.) 4. VSL link port exception Troubleshooting steps 1. Basic information confirmation 1.1 Check whether the device version and model are consistent. You can use 'show ver' to check the specific device model and version. If the version is inconsistent, the VSU may can't be built. ![]() 1.2 Check if the VSU configuration is correct You can use 'show switch virtual config' to check device VSU configuration Check: whether the domain ID is consistent, whether the switch ID is inconsistent, and whether the vsl link port is correct ![]() If the domain ID is inconsistent / switch ID isconsistent/ VSL link port configuration is abnormal, it will cause the VSU to fail to build. Such as: Device Switch ID consistent Configure the Switch ID of the two switches to beconsistent, and the switch information that failed the election cannot beviewed by the VSU master device. Both devices are ACTIVE ![]() ![]() 2. Confirm whether the VSU device is in VSU mode You can use 'show switch virtual' to check the device vsu status ![]() If one of the VSU devices is in standalone state, the VSU cannot be established 3. Confirm VSL link is abnormal Using 'show int xxx' to check whether the VSL port status is normal and whether there are abnormal phenomena such as error packet loss undert he interface ![]() Using 'show int xx tran' to check if the vsl link port receives light attenuation normally ![]() Using 'show switch virtual link'. The state shows up to indicate that the status is normal. ![]() Using 'show switch virtual link port' to check if the VSL link status is normal. "DOWN" means the current port physical isLINK DOWN; "DISABLE" indicates that the current porthas an error frame; "UP" indicates that the current port isphysically LINK UP, but it has not been detected that the other end is a validVSL-AP member port; "OK" indicates that the port is not onlyphysically LINK UP, but also detects that the peer is a valid VSL-AP memberport. ![]() Information Collection 1. Use full script tocollect directly 2. Collect the following information when unable touse the full script: Show ver Show ver detail Show sw for conf Show sw for Show int Show int tran show switch virtual link show switch virtual link port Show run Show log Summary and Recommendations Generally, the wrong configurations of switchesare the main causes of VSU exceptions. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd