【Typical Case】How to Configure Scheduled Restart on NBR Devices?

Keywords:

Scheduled Task, Scheduled Restart
1. Configuration Requirements
Configure an NBR device torestart at 01:00 every day.
2. Device Model and Firmware

Device Type	Device Model	Firmware  Version
		RGOS11.9(6)B17P2

3. Configuration Notes

• Configure the device to savelogs to the hard disk.
• Configure a scheduled task.
  

4. Configuration Procedure

4.1 Configuring the Device to Save Logs to the Hard Disk

• Log storage priorities for scheduled tasks: Hard disk > eMMC > USB flash drive > SD card > flash memory.
• In the NBR6200 series, theNBR6120-E supports scheduled tasks by default. For other models, enabling Save Logs Locally is required. Scheduled restarts are supported following device restarts (Note: A hard disk is necessary for other scheduled tasks).
• Save Logs Locally
  is disabled by default on the NBR6200-E. Configuration of scheduled tasks is only available after Save Logs Locally is enabled. To enable Save Logs Locally, choose Advanced > System > Enhancement > Save Logs Locally > Disable. Uncheck the box next to Disable.
  

Configuration path:
Choose Advanced > System > Enhancement > Save Logs Locally > Disable.
By default, the box next to Disable is checked, meaning logs are not saved to the hard disk. To ensure a scheduled task has the highest priority, uncheck the box next to Disable to save the logs to the hard disk.


Note: After unchecking Disable, restart the device to apply the configuration. Then proceed to configure ascheduled task.
4.2 Configuring a Scheduled Task
After the scheduled task function is enabled on the NBR6200-E, it cannot be configured through the web interface. You must use the CLI to configure this function.
1. Run the following command toenable the User Task function.
user-task enable

2. Configure a one-time scheduledtask.
reload at hh:mm:ss month dayyear

3. Configure a recurring scheduled task. (Enter ruijie# in privileged EXEC mode)
user-task add aa command“reload@y” mode exec date 2018 9 4 time 3:00 every 24:00

Run the preceding command to configure a recurring task named aa that restartsthe device daily at 3:00.
Note: The configured time cannot be earlier than the current system time. Otherwise, the device will restart immediately. Please exercise caution.
4. View a scheduled task.
When you run the show run command, the scheduled task configuration will not appear. The output of show run only displays user-task enable without showing the detailed configuration. To view the scheduled task configuration, use the show user-task command.
5. Delete a scheduled task.
NBR2500D-E#user-task deleteaa  ---aa indicates the task name.