Why loop detect alert didn't show in my switch
|
I dont have alert or have messages when i tried fourth times to simulate loop detect. I put a 2 metre cable to port 9 and 15 and it doesn't show any alert or messages. I have change port too, it doesn't show any alert. My action was warning then shutdown. I use NBS3100-24GT4SFP v2 Firmware ReyeeOS 2.280.0.1709 I try to upgrade to latest firmware and the messagea and alert still did not show. I have activate rdlp Can anyone help me. |
|
Dear, To see the alerts, where are you testing, in the app or in the cloud? Did you not have this issue with a previous firmware version? Thanks. Best regards. |
GTAC-AnaKarenDuranUrrutia replied at 2024-9-20 06:40 I do both web and apps but it just didn't show any messages or alert, i have Enable RLDP. |
RSI Banjarnegara replied at 2024-9-20 21:35 Hi Sir, Did you check if the switch are detecting the loop on the system logs on eweb tunnel? Also can check the logs to see if device has any RLDP alarm Regards |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
