Enable the broadcast storm function of port 1 and limit the broadcast storm level to 1, that is, 1% of the port bandwidth. Ruijie> enable Ruijie# configure termina Ruijie(config)# interface gigabitEthernet 1/1 ------> You can use the interface range command to set the same control policy for ports in batches. Ruijie(config-if-Gigabit Ethernet1/1)# storm-control broadcast level 1 ------> Enable broadcast storm suppression. The level is1, that is, 1% of the port bandwidth, that is, 1% of 1G, 10M. Ruijie(config-if-GigabitEthernet1/1)# storm-controlunicast level 1 ------> Enable unknown storm multicast storm suppression.(The switch did not learn the target MAC address of the packet and its level is1. That is 1% of the port bandwidth, that is, 1% of 1G, 10M. Ruijie(config-if-GigabitEthernet1/1)# storm-control multicast level 1 |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd