How to setup ssid as the following details

Hello,

    I woud like to config the ssid as the following details with 4 APs.
AP1 : SSID#1, SSID#2, SSID#3
AP2 : SSID#1, SSID#2
AP3 : SSID#1, SSID#2
AP4 : SSID#1

SSID#1 broadcast every APs           (5Ghz & 6GHz)
SSID#2 broadcast AP1, AP2, AP3    (2.4GHz)
SSID#3 broadcast only AP4             (2.4GHz)

AP1 : RAP62OD
AP2 : RAP73Pro
AP3 : RAP73HD
AP4: RAP1261

Please advice how to config as above details.

Hello Tinman,

You can achive that configuration creating device groups on your project.
-General group: here you create the SSID#1, this configuration will apply on all your devices
-Group1: here you need to add the AP1, AP2 and AP3 and create the SSID#2
-Group2: here you need to add the AP4 and create the SSID#3

On that way devices will only broadcast the ssid of their group and the general group.

To create a device group you can do it as follows:





When you create the ssid, be sure to select the correct group


Regards!

TAC-Saul replied at 2024-10-25 08:30
Hello Tinman,

You can achive that configuration creating device groups on your project.

Dear TAC-Saul,
Thank you for your prompt response.
I have implemented the settings as per your instructions. Specifically, I moved RAP62OD to Group 1 and created the SSID "TEST." Upon reviewing the access point details, I observed that it is only broadcasting the "TEST" SSID, without broadcasting the general group SSID.
Could you please confirm if I may have made an error in the configuration?
Thank you for your assistance.
Regards

Tinman replied at 2024-10-27 21:40
Dear TAC-Saul,
Thank you for your prompt response.
I have implemented the settings as per your ins ...

hi sir
i think you can come to rita and share your project ,we will help you fix the issue