Mesh with Rap-6260H
|
Hello, I have a Rap-6260H connected by lan. I just buy a Rap 6262h because I want to mesh it with the 6260H. The 6260h doesn't have a mesh button. How can I connect them? (my 6262h is not the primary router) |
|
Dear sir there are no mesh button on the Reyee AP , the mesh function is enable by default , you can refer the following link to mesh RAP Mesh Networking Introduction - Wireless - Ruijie Community (ruijienetworks.com) |
GTAC-Joy replied at 2024-5-7 12:06 Today I tried but the 6262 doesn't connect with the 6260H. They are 15mt away from each other. The 6262 is installed on a guest house with a different electrical system. Can a different electrical sistema respect the main house cause this problem? |
Matteo Vitale replied at 2024-5-11 05:15 Dear sir Different device models can also be mesh. Please pay attention to a few points during the configuration process. 1. The slave AP must be factory-set. 2. The slave AP cannot be wired into the same network as the master device 3. Both APs must be the latest version |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
