|
Note: RIPng (Routing Information Protocol next generation) is a unicast routing protocol applied to IPv6 networks. Network Segment/Port List You can Click [Device]> [Routing]> [RIPng Settings] > [RIPng Settings] Click [Add], set Type to Network Segment or Port, and specify the network segment or port accordingly    Type: Network Segment: Enable RIP in the specified network segment. The IP addresses of this network segment are added to the RIP routing table, and the device and its RIP-enabled neighbor devices learn the routing table from each other. Port: Enable RIP on the specified port. All the IP addresses of this port are added to the RIP routing table, and the device and its RIP-enabled neighboring devices learn the routing table from each other. Network Segment: Enter the IPv6 address and prefix length when the Type is set to Network Segment. RIPng will be enabled on all interfaces of the device covered by this network segment. Port: Select a VLAN interface or physical port when Type is set to Port. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
