|
In the Cloud.Click the SN of the device Select Ports and change the status to Enabled, Speed to 10M (maximum Speed), Duplex to full Duplex   3.In the web interface you can Click[Switch Setting]-->[Port Setting] Select Ports and change the status to Enabled, Speed to 10M(maximum Speed), Duplex to full Duplex.  Note: Data transmission distance is limited by the transmission medium. When your transmission speed is higher, the signal frequency is relatively high. In different media produced at different intensity of interference, it may become a barrier to data transmission, thereby affecting the bit error rate of data! In other words, the lower the speed, the longer the transmission distance |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 5
