How to configure IP-based rate limiting on the new Ruijie Cloud?

1.What is the IP-based rate limiting?

IP-based rate limiting is used to limit the rate of a single IP or IP range. You can limit both application and rate.

Note:IP-based rate limiting function supported by Reyee and Ruijie Gateways

2.How to configure it on the new Ruijie Cloud?

1)Topology(EG105GW-X is used as an example)



2)Enter your project through the new Ruijie cloud. Click Network-Wide---Traffic Control



3)Click To configure under 1 Flow Control



4)Select Template as your environment and configure wan port rate



5)Clicek Custom traffic control policy---Add---IP Traffic Control



6)Custom traffic control policy (Take a single IP address as an example)







Note:Overall rate limit: Indicates that all users(all IP addresses in an address range)share the configured uplink and downlink bandwidths, and the bandwidth of a single user is not limited.

Per IP rate limit: Indicates that all users(all IP addresses in an address range) share the configured uplink and downlink bandwidths, and the maximum bandwidth of a single user can be limited.



7)check the policy



8)Verify configuration

Before enable



         

After enabling

Thankyou very helpful