RAP Devices VLAN Configuration without Controller
 There is a configuration similar to this. Can I broadcast many SSIDs over different VLANs via the Master device without an AP controller? All cables are on the WAN port and all are set to "Trunk" on the Switch. |
|
Dear: You can deploy the configuration above as long as you meet with the following Yes, you can set different SSIDs over different VLANs via the master device without a controller, but I need to ask you: may I know where is the DHCP server? because RAP2260(G) can not act as this one. So, need to consider an uplink device that works as a gateway and DHCP server. If this requirement is met, you can deploy it. Regards, Javier |
GTAC--Javier replied at 2023-11-29 08:45 Yes sir. I have a DHCP server (windows) and I set the ip helper address to all vlans. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
