How to configure port security on CLI for Ruijie Series Switch?

Requirement:
1.
PC1（IP: 192.168.1.1，MAC: 0021.CCCF.6F70）canonly connect to access switch F0/1，and configure IP+MAC binding other PC conenct to this port cannot be accessed when connected to this port；
2. F0/2port can only allow ip address 192.168.1.2 access to the internet, MAC address is not limited other ip address cannot access internet when connected to this port.
Topology:
\

Configuration tips:
On ports F0/1 and F0/2, you need to enable switchport port-security and limit MAC address binding entries to 1
Configuration Steps:
>Requirement 1:
In core switch:

Ruijie>en
Ruijie#config ter
Ruijie(config)#vlan 10
Ruijie(config)#interface vlan 10
Ruijie(config-if-VLAN 10)#ip address 192.168.1.254255.255.255.0      --->Create the IP address of the core device, that is, the gateway address of the user

Ruijie(config-if-VLAN 10)#end
Ruijie#wr    ---> save the configuration

In access switch:

Ruijie>enable   
Ruijie#configure terminal
Ruijie(config)#interface fast Ethernet 0/1                                   

Ruijie(config-if-Fast Ethernet 0/1)#switchportport-security binding 0021.CCCF.6F70 vlan10 192.168.1.1   ---->   Bind the PC whose mac address is0021.CCCF.6F70 and ip address is 192.168.1.1 to the fastEthernet 0/1 port onthe switch

Ruijie(config-if-FastEthernet 0/1)#switchportport-security  ------>enableport security function

Ruijie(config-if-FastEthernet 0/1)#exit
Ruijie#write       ---> save the configuration

>Requirement 2:
Ruijie(config)#interfac fastEthernet 0/2
Ruijie(config-if-FastEthernet 0/2)# switchportport-security binding 192.168.1.2  ------>Bindthe PC whose ip address is 192.168.1.2 to the fastEthernet 0/2 port on the switch

Ruijie(config-if-FastEthernet 0/2)#switchportport-security  ------>enableport security function

Ruijie(config-if-FastEthernet 0/2)#end
Ruijie#write    ---> save the configuration

Verification:
Ruijie#show port-security address