After hardware reset (factory defaults, holding reset button more than 5 seconds) Device is still in RED LED blinking mode Before that first was blinking green, than steady green, than again green and got in to red blinking status since than. It s already 20 minutes in that condition and status is not changing.. Happened on 2 devices.... Device is just connected to PoE injector 48V , not connected to internet |
After factory reset, ruijie AP will be in the Fit mode. You can check the hardware guide about the LED status of AP820-L(V3) in Fit mode: https://www.ruijienetworks.com/resources/preview/77234?t=638138139210205078 Could you connect your PC to AP's LAN 1, set IP of your PC into 192.168.110.x/24, then login to the eweb of this AP via this default ip: 192.168.110.1? Check if the eweb of AP is available or not. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd