How to allow VLAN to pass through the LAN port of EG210G-P? - Router

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Account(User Center, Log in/out etc.)
Content(Post is marked as spam or post fails to publish, etc.)
Ruijie Community improvement suggestion

Your Feedback

Your Email address (optional):

How to allow VLAN to pass through the LAN port of EG210G-P? Reply

GTAC-Sophia

Level 5

Ruijie Staff

Back + Ask a related question

How to allow VLAN to pass through the LAN port of EG210G-P?

1994 0 2023-1-18 16:13:50 Subscribe

Original

If you want to allow other VLANs to pass through the LAN port, you need to create a sub-interface under the LAN interface, Here we take VLAN10 as an example:
Web:
1.Select LAN port and then click "Sub interface."

1. Configure VLAN10 and IP addresses

CLI:

EG2100-P(config)#interface gigabitEthernet 0/2.1
EG2100-P(config-subif-GigabitEthernet0/2.1)#encapsulation dot1Q 10
EG2100-P(config-subif-GigabitEthernet 0/2.1)#ipaddress 192.168.10.1 255.255.255.0

RG-EG210G-P

Configuration Router

Reply Helpful(0)

There are no replies.

Product Model

Router

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

		Remember me	Forgot password?
Password			Register now