When I'm deploying bridge configuration, I set the bandwidth to be 40HZ but it doesn't work
|
When I'm deploying bridge configuration, I set the bandwidth to be 40HZ but it doesn't work. what's the problem? what should I check ? |
|
It may be because that the channel isinterfered by other channels or the channel configuration is incorrect. (1) When the AP detects that the channel interference protection mechanism is enabled during startup, it automatically adjusts the bandwidth to 20 MHz. (2) The channel configurationis incorrect. When the 11a bandwidth is set to 40 MHz, only the channels 149 and 157 can be used. of which the effect is equivalent to channel 149 + channel 153, and channel 157 + channel 161. If the working channel is 165, switchover fails because there is no higher frequency band for extension.Therefore, when the bandwidth is 40 MHz, use the channel 149 or the channel157. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
