|
There is no responding when telnet device via SNC. |
|
Step 1: This fault is caused when the safety strategy of the Internet Explorer (IE) forbids the direct calling of Telnet in the IE. In this case, you can change the registration table by copying the following content to the notebook, save it as a .rag file, and double click it to run the file. REGEDIT4 [HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Internet Explorer\Main\FeatureControl\FEATURE_DISABLE_TELNET_PROTOCOL] "iexplore.exe"=dword:00000000. If the fault persists, proceed to Step 2. Step 2: Install SecureCRT on the PC, and choose Options > Global Options > Web browser to set SecureCRT as the default Telnet program, and try to telnet again. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
