EG3250 cannot set 2 same VLAN ID for 2 WANPPPOE. It will fail if when you use you use the same VLAN ID twice, the notewill be shown as: the VLAN ID already exists:  |
|
And if instead of PPPOE clients, they were DHCP clients? The "multiwan" scenario would consist of 6 symmetric 1Gbps FTTH accesses with public IPs delivered in the same VLAN = 20 on each WAN Ethernet interface. |
CTO Nexo replied at 2023-6-8 03:39 If use DHCP on WAN port, then it will has same limitation with PPPOE, that is cannot set 2 same VLAN ID for 2 WAN   |
GTAC-Micca replied at 2023-6-8 10:27 Ok, thanks. Then I will set up the vlan20 for the first interface and setup a dmz for the wan2, wan3... so as to push the ip public address to that interfaces. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 5
