In the configuration template, the default-router command is not configured for the DHCP pool. Does this affect the client to obtain the IP address of the gateway? |
In network planning, if the default-router command is not configured, the device sends the interface address, as the gateway address, to the client by default. For example, if the network segment configured for the DHCP is 10.0.0.0/24 and the IP address of the VLAN100 interface is 10.0.0.1/24, if the default-router command is not configured, the device sends the IP address of the SVI100, as the gateway address, to the client. It is recommended to configure ”default router” during network deployment because it makes the configuration command planning clear and easy to check. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd