|
Edited by Eureka at 2022-6-6 15:29 Networking Requirements The users in the 192.168.10.0/24 network segment can access to local switch by telnet. Network Topology  Configuration Points 1.Before configuring the following steps, please make sure that you can access to the switch by telnet and SSH normally. 2. Configure ACL 3. Apply ACL under VTY interface Configuration Steps Step1: Configure ACL Ruijie>en Ruijie#config ter Ruijie(config)#ip access-list extended 100 Ruijie(config-ext-nacl)#5 permit ip 192.168.10.0 0.0.0.255 any----->Only the administrator network segment is allowed to access the switch Ruijie(config-ext-nacl)#exit Step2: Apply ACL under vty interface Ruijie(config)#line vty 0 4 Ruijie(config-line)#login Ruijie(config-line)#password ruijie Ruijie(config-line)#access-class 100 in Step3: Save running-configuration Ruijie(config-line)#end Ruijie#write----->Ensure that the configuration is correct and save the configuration |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
