ACL and OpenVPN Client

Good day,

I need to setup a vpn tunnel into my network with ACL rules limiting the addresses that the vpn user can access.

For example: user creates a vpn connection and gets assigned IP address: 192.168.100.10. 2 VLANs exist (192.168.1.0/24, and 192.168.2.0/24). This user should only be able to access the 192.168.2.0/24 range.

When using a PPTP vpn setting the ACL rules works perfectly. When using openvpn with "Route all traffic over vpn" it seems the ACL rules are ignored.

Any suggestions?

Dear sir,

could you help show me your setting？

GTAC-Daisy replied at 2022-8-19 17:38
Dear sir,

could you help show me your setting？

Hi,

Thanks for the reponse.

OpenVPN Config:


ACL Rule:

Nicolaas Lynzaad replied at 2022-8-19 19:26
Hi,

Thanks for the reponse.

The setting is OK, let me confirm with our staff first.

Nicolaas Lynzaad replied at 2022-8-19 19:26
Hi,

Thanks for the reponse.

Dear sir,
as confirm with our staff, that is limitation of the current version. Will resolve it on next version. sorry for the inconvenience all caused.

GTAC-Daisy replied at 2022-8-23 15:37
Dear sir,
as confirm with our staff, that is limitation of the current version. Will resolve it on ...

Hi,

Thanks a lot for the response. Glad to hear it will be resolved in the next version.

GTAC-Daisy replied at 2022-8-22 10:54
The setting is OK, let me confirm with our staff first.

Hello! Can you please help me with below feature request related to OpenVPN? As a seasoned network engineer, this is very valuable, to be able to set static routes over OpenVPN tunnels back to the remote sites. Thanks!

https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=4212

Nicolaas Lynzaad replied at 2022-8-23 20:19
Hi,

Thanks a lot for the response. Glad to hear it will be resolved in the next version.

Dear sir,

The firmware is released
https://www.ruijienetworks.com/support/documents/slide_77329