why the interface rate is 20G when use the M5000H-01QXS as an expansion module？ - Switch

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Account(User Center, Log in/out etc.)
Content(Post is marked as spam or post fails to publish, etc.)
Ruijie Community improvement suggestion

Your Feedback

Your Email address (optional):

why the interface rate is 20G when use the M5000H-01QXS as an expansion module？ Reply

GTAC-Wayne

Level 2

Back + Ask a related question

why the interface rate is 20G when use the M5000H-01QXS as an expansion module？

2277 0 2022-3-9 10:24:47 Subscribe

Original

M5000H-01QXS support 40G QSFP+ port for stack.

Because the M5000H-01QXS supports up to 21Gbps rate for stacking, so when check in cli, it shows 20G, shown in this picture:

Reply Helpful(0)

There are no replies.

Product Model

Switch

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

		Remember me	Forgot password?
Password			Register now