Ruijie AP Limit Bandwidth

Hi, how can i limit bandwidth coming from AP? i have a mikrotik router, already configured limiting the bandwidth of AP per IP, but when i connect to AP, nothing happened. Or should i limit the rate of per port of ruijie switch?

Thanks for the answer

Hello dear
Thanks for contacting us.
May i know how you configured the rate limit on AP?
For RAP2260(G) it can support Client-based Rate Limiting, SSID-based Rate Limiting,AP-based Rate Limiting and Packet-based Rate Limiting.
You can refer to the following guide to check if you got the correct configuration.
Ruijie Networks | Network Devices and Solutions Provider

Best regards
Sean

GTAC-Sean replied at 2024-9-5 08:53
Hello dear
Thanks for contacting us.
May i know how you configured the rate limit on AP?

So it can support Client based, AP Base rate limiting without using EG Gateway?

Kevin Bryan Laurea replied at 2024-9-5 09:04
So it can support Client based, AP Base rate limiting without using EG Gateway?

I want to put limit per AP, how can i do this?

Kevin Bryan Laurea replied at 2024-9-5 09:32
I want to put limit per AP, how can i do this?

Hi!
about your need, you can check Configuring
AP-based Rate Limiting.

Choose
Network-Wide
> Workspace > Wireless > Rate Limiting > AP-based Rate Limiting.

(1)
Enable Wireless Rate Limiting.

(2)
Set the uplink and downlink rate limit modes to Rate Limit Per User, configure the rate limit values, and click OK.

If you think this function still can't meet your needs.
You can directly limit the port speed of the switch that the AP connect with.