|
Edited by Oscar at 2018-7-5 15:58 Step 1: Prepare one console cable and install Putty software on your laptop. Step 2: Connect your laptop to RG-WS6008's console port with console cable. Step 3: Open Putty, select corresponding serial line shown on your PC and change the Speed to 9600 
Step 4: Configure an IP address for controller and enable EWEB service by following command. Ruijie>enable Ruijie#configure terminal Ruijie(config)#enable service web-server ---->Enable EWEB service Ruijie(config)#interface vlan 1 Ruijie(config-if-vlan 1)#ip address 192.168.110.1 255.255.255.0 Ruijie(config-if-vlan 1)#exit Ruijie(config)#webmaster level 0 username admin password 123456 ---->create account admin/123456 for WEB login Ruijie(config)#end Ruijie#wr ---->Save the configuration Step 5: Configure the PC with the same network segment IP (such as 192.168.110.2, the mask is 255.255.255.0), and connect your PC ethernet port to controller. After that, you can log in http://192.168.110.1 through the browser. |
Putty.jpg (142.13 KB, Downloads: 371)
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
