my ap cannot upgrade automatically
|
hello, guys I found when I connect my ap to the poe switch and can be controlled by AC, however it cannot upgrade automatically. what should I check ? |
|
(1) Check whether the AP can obtain the IP address: show ip int brief. (2) Check whether the AP can obtain the IP address of the AC: show ap-statistic aclist. (3) Check whether the AP can communicate with the AC: pingx.x.x.x(ac-ip). (4) Check whether the version span of the AP and AC is too large (the AP is upgraded from 2b15 directly to 1b19p2, and the AC is upgraded from 10.x directly to 11.x, instead of the intermediate version). (5) Check whether the software of AC version supports the AP of this model (refer to the version release notes). If the problem persists after the above steps, collect the following information and contact our online support for help. The AC information needs to be collected: show version show run show log The AP information needs to be collected: show version show log show ip int bri show inteface The name and size of the version needs to be upgraded. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
