How to reset the enable password of AP740-I ?
|
How to reset the enable password of AP740-I ? |
|
Note: This password recovery only for 11.X fatAP mode. Step 1-By input command ‘ctrl+c’ continuouslyto enter uboot, and then use command ‘ctrl+q’ to enter CLI. Step 2-Input command ‘ubootui’ and click ‘enter’. 
Step 3-Implement command ‘ctrl+p’ immediately.
Step 4-Implement ‘setenvrunlevel 1’ and ‘run linux’. (System will restart in this time.)
Step 5-Use command ‘vi /data/config.text’ torevise configuration file. Input：/password (Enter) Press ‘D’ for 2 times.
Step 6-By command ‘:wq!’ save and exit. Input ‘init 3’ continuouslyfor 2 times, system will restart. Step 7-After restarting, reload device. Enterubootui again according to step 1-2-3. (This step is necessary, or it will leadto when AP restarts every time, it will enter linux interface. If you haveentered linux interface, you can enter main interface by inputting ‘init 3’ continuouslyfor 2 times.) Step 8-Input ‘setenvrunlevel 3’ and ‘saveenv’. Run ‘run linux’. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
