How to configure PBR on Reyee EG to control your traffic?

Requirements:
1. Atleast 2 ISP cable provide internet connection for Reyee EG
2. Configured WAN load balancing policy to be Based on Link (Basics>>WAN>>Dual-Line>>ISP/Load Settings)


Steps:
1. Go to Advanced>>Routing>>PBR>>Click Add


2. Enter the following parameters:
Name: IT Department (Example Department)
Protocol: IP (Can be IP, ICMP, TCP, UDP, or Custom protocol number)
Src IP/IP Range: Custom
Custom Src IP: 192.168.20.2-192.168.20.254 (Subnet of IT Department)
Dest IP/IP Range: All IP Addresses (Or any specific destination)
Outbound Interface: WAN or WAN1 (Depends on what ISP you want the traffic to go)
Click OK



3. Do the same step for other subnets (Example Sales Department will go to WAN1)



4. Test using CMD
IT Department (192.168.20.0/24) will go to WAN0 (192.168.1.1)

Sales Department (192.168.30.0/24) will go to WAN1 (192.168.111.1)

Saludos bendiciones tengo un problema que estoy enrrutando el protocolo pbr por URL para que una web en especifico salga por una wan especifica y veo que a ves dale por la wan que le coloco para que salga el trafico pero veo que a veces es sale por la otra wan que no le he dicho que salga que puedo hacer

diego torres replied at 2024-3-18 00:15
Saludos bendiciones tengo un problema que estoy enrrutando el protocolo pbr por URL para que una web ...

Dear sir

Can you take a screenshot for your configuration ?  did you have configured the NBR for the user ip address ?