Mesh AP not linking to strongest signal
|
Hello there, I have EG105GW-X as gateway and few wired RAP2260(G) and one wireless RAP2260(G) that has been meshed, however, it always connects to EG105GW-X instead to close by wired RAP2260(G). Is there any way for me to manually set it up through cloud or to scan and choose which AP I would like to connect to? I don't want to run AI tools. |
|
Dear sir in that case, you can configure wireless repeater mode on the AP and you can manunlly choose the SSID you want to expand the wifi coverage Best regards, ROss |
Edited by Alexander P at 2024-7-12 21:35 GTAC-Ross replied at 2024-7-12 21:29I was thinking about it but I'm not on site any longer, can I tunnel into mesh AP and do it without being disconnected to finalise the setup? It looks like I have to set it up from the scratch.  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
